GE JGP990 - Manual (Page 30)

30
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at:
ge.com
LP Conversion Gas Cooktop
Instructions
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these
instructions for future reference.
BEFORE YOU BEGIN
• This cooktop is factory set for natural gas operation.
Conversion to LP operation should be performed by
a qualified technician or installer. Keep these
instructions for future reference. When converting
to LP, save the original parts for possible future use.
• Product failure due to improper installation is not
covered under the GE Appliance Warranty.
WARNING –
If you are using LP (bottled)
gas, all adjustments described in the following steps must
be made before attempting burner adjustments or use of
the cooktop.
WARNING –
This conversion kit shall be
installed by a qualified service agency in accordance
with the manufacturer’s instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instructions is
not followed exactly, a fire, explosion or production
of carbon monoxide may result, causing property
damage, personal injury or loss of life. The qualified
service agency is responsible for the proper installation
of this kit. The installation is not proper and complete
until the operation of the converted appliance is
checked as specified in the manufacturer’s instructions
supplied with the kit.
FOR YOUR SAFETY:
Adjustable wrench
TOOLS YOU WILL NEED
PART QUANTITY
Brass orifices 4
Stick-on conversion label 1
PARTS INCLUDED
Small, thin-blade flat screwdriver with approximately 1/8 ″
blade width is needed to access the calibration screw.