Charcoal filter, Hood light, Hood surfaces – GE 164D4290P393 User Manual

Page 5: Hood light hood surfaces

Advertising
background image

Installation Instructions

Consumer Support

Safety Instructions

Operating Instructions

Do not use steel-wool pads or other
abrasive cleaners. They will scratch
the surface.

Clean grease-laden surfaces of the
hood frequently. To clean the hood
surface, use a hot, damp cloth with a
mild detergent suitable for painted
surfaces. About one tablespoon of
ammonia may be added to the water.
Use a clean, hot, damp cloth to
remove soap. Dry with a dry,
clean cloth.

NOTE: When cleaning, take care not
to come in contact with filters and
other non-enameled surfaces.

CAUTION: When cleaning the hood
surfaces, be certain that you do not
touch the light bulb with moist hands or
cloth. A warm or hot light bulb may break
if touched with a moist surface. Always
let the light bulb cool completely before
cleaning around it.

Painted Surfaces

CAUTION: Let the light bulb cool
completely before removing.
A warm or hot bulb may break
if touched with a moist cloth
or hand.

Remove the bulb and replace with
an ordinary screw-base light bulb,
not more than 60 watts.

To remove the light cover
(on some models):
• Press the sides with two fingers

until the side prongs are
released.

• Lift the light cover and slide it

toward you in one motion.

To replace the light cover:
• Insert the prong located at the

end of the cover into the top
opening.

• Gently push the cover up and

press the sides to fit the side
prongs into the side openings.

• Release and the cover will lock

in position.

Hood Light

The charcoal filter cannot be
cleaned. It must be replaced. Order
filter no. WB02X10700. Replacement
filters can be ordered from your GE
supplier.

If the hood is not vented to
the outside, the air will be
recirculated through a disposable
charcoal filter that helps remove
smoke and odors.

The charcoal filter should be
replaced after 6 to 12 months
(depending on hood usage).

To remove:
Pull down on the center of the
front edge of the filter. The filter
will then slip out of the retaining
tabs on the back.
To replace:
Slip the back edge of the filter
into the retaining tabs and push
the front edge up until it snaps
into place.

Charcoal Filter–Recirculating Installations Only

Replaceable charcoal filter

5

NOTE: DO NOT rinse, or put charcoal filters in
an automatic dishwasher.

Light cover

Advertising