Grizzly G0705 - Manual (Page 18)

-16-
Model G0705 (Mfg. since 09/09)
figure 12. inventory.
g
e
C
d
F
h
i
J
K
l
inventory
crate contents (figures 11 & 12) Qty
a. Cabinet Base .............................................. 1
b. Machine ...................................................... 1
c. toolbox ....................................................... 1
d. drill Chuck B16 1–13mm ............................ 1
e. drill Chuck arbor r8–B16 .......................... 1
f. lug Wrench ................................................ 1
g. t-Bolt assemblies ....................................... 2
—t-Bolt M14-2 x 55 .................................... 2
—Flat Washer 14mm .................................. 2
—hex Bolt M14-2 ....................................... 2
h. drill Chuck Key ........................................... 1
i. drift Key ...................................................... 1
J. Collet adapter r8 to Mt#3 ......................... 1
K. Collet adapter Mt#3 to Mt#2 .................... 1
l. Bottle For oil .............................................. 1
not shown
• hex Wrenches 3, 4, 5mm ..................1 each
• hex Bolts M10-1.25 x 140 ........................... 4
• Flat Washers 10mm ................................... 4
• lock Washers 10mm .................................. 4
• open-end Combo Wrench 17/19mm ......... 1
• hex Bolts M12-1.75 x 40 ............................. 4
• hex nuts M12-1.75 ..................................... 4
• Cap screws M6-1 x 16 ............................... 3
• Flat Washers 6mm ..................................... 3
• drawbar ...................................................... 1
figure 11. Main inventory.
a
B
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.