Grizzly G0705 - Manual (Page 40)

-38-
Model G0705 (Mfg. since 09/09)
section 6: maintenance
always disconnect power
to the machine before
performing maintenance.
failure to do this may
result in serious person-
al injury.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
daily check:
•
Make sure mill/drill is disconnected from
power when not in use.
• Check for loose mounting bolts.
• Make sure mill/drill is clean and lubricated.
• Check for worn or damaged wires.
• Check for any other unsafe condition.
monthly check:
•
Check that gibs are adjusted properly.
biannual check:
•
lubricate table leadscrews.
schedule
Metal chips left on the machine that have been
soaked with water-based coolant will invite oxi-
dation and a gummy residue buildup around the
moving parts. use a brush and shop vacuum to
remove chips and debris from the working sur-
faces of the mill. never blow off the mill with com-
pressed air, as this will force metal chips deep into
the mechanisms and may cause injury to yourself
or bystanders.
remove any rust build-up from unpainted cast
iron surfaces of your mill and treat them with a
non-staining lubricant after cleaning.
Keep unpainted cast iron surfaces rust-free with
regular applications of products like g96
® gun
treatment, slipit ® , or Boeshield ® t-9 (see the
grizzly catalog or website).
cleaning and
protecting