Grizzly G0705 - Manual (Page 36)

-34-
Model G0705 (Mfg. since 09/09)
depth stop headstock position
the depth stop is used to limit the range of down-
ward movement by the drill bit or cutter. Maximum
depth is 4
11 ⁄
16
".
to calibrate the depth stop:
1. install the cutting tool, then make sure the
spindle is drawn all the way up into the head.
to prevent damaging the workpiece, place a
piece of paper on the workpiece. loosen the
headstock locking nuts and lower the head
until the drill bit or cutter just contacts the
paper. tighten the headstock locking nuts.
(refer to
figure 40 for the location of the
headstock locking nuts).
2. turn the knurled knob of the depth stop
leadscrew until the top of the indicator plate is
level with your desired depth as listed on the
scale to the left or right (
figure 41).
the headstock height and rotation on the Model
g0705 can be adjusted for various applications.
For increased quill rigidity and reduced vibrations,
which will produce the best results, keep the quill
fully retracted and set the headstock as low as
possible.
to adjust the headstock height:
1. using the lug wrench provided, loosen the
two headstock locking nuts located on the
right side of the head near the back (
figure
40).
figure 40. headstock locking nuts.
2. use the head crank to move the head up
or down, and rotate the headstock by hand
according to your needs.
3. tighten the two head locking nuts.
figure 41. typical setting of depth stop.
indicator plate
Knurled Knob