GE VG4250 - Manual (Page 20)

18 Chapter 2
Using On-Screen Menus
Changing the Signal Type
This feature is useful if your cable signal goes out; it allows you to switch to a
regular antenna for alternate television reception.
1. Press MENU to display the VCR MAIN MENU.
2. Press 3 to display the CHANNELS menu.
3. Press 3 to change Signal Type: Cable or Antenna. When finished, press 0 to
exit back to the MAIN MENU and 0 again to exit to normal viewing.
Adding or Removing Channels
You might want to add or remove channels after using Auto Channel Search,
especially if there are weak signals or channels with content you don’t care for.
1. Press MENU to display the VCR MAIN MENU.
2. Press 3 to display the CHANNELS menu.
3. Press 2 to display the ADD/REMOVE CHANNELS menu. To go to the
channel you want to add or remove, use the remote control’s CHANNEL +
or – buttons or enter a specific channel number using the number buttons.
When the desired channel is shown, the on-screen display will tell you if the
channel is currently in your viewing list. Press CLEAR to remove a channel
from the available channels list or press INFO to add it.
4. Once you are finished adding/deleting channels, press the MENU button
to exit out of the menus.
Note: To view active channels, use the remote control’s CHANNEL + and -
buttons. You can also access channels not available in the active channel list by
using the remote control’s number buttons to enter the specific channel number.
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type: CABLE
4 Cable Box Setup
0 Exit
ADD/REMOVE CHANNELS
Channel 115
is presently ADDED
Press CLEAR to remove
Press MENU to exit
VCR MAIN MENU
1 Timer Recordings
2 Time
3 Channels
4 Setup
5 Preferences
6 Audio
7 Language
0 Exit