GE VG4250 - Manual (Page 29)

Chapter 3 27
Using the Remote Control
MENU Displays the VCR’s Main Menu. This is the first step when accessing any on-screen
menu such as Language, Preferences, Timer Recordings, etc.
MUTE Lowers the TV volume to its minimum level. Press the MUTE button again to restore
the TV’s volume to it previous level.
ON•OFF Turns the power of the active device (either the TV or VCR) on or off.
PAUSE Pauses playback in VCR mode.
PLAY Starts playback when in VCR mode. Pressing PLAY while in Pause mode will also start
playback.
RECORD Starts recording when in VCR mode.
REVERSE If you’re operating a VCR with the remote control, press REVERSE to go backwards
on a videotape. While in playback mode, pressing and holding REVERSE starts reverse
playback.
SEARCH Displays INDEX and GO-TO Search menus on TV screen when VCR is stopped. The
Commercial Scan feature advances the tape 30 seconds of recorded material during playback.
Each press advances the tape an additional 30 seconds up to five minutes.
SPEED Overrides the set recording speed (either SP or SLP).
STOP Stops the active function of the VCR including tape playback, rewinding, and fast-
forwarding. Pressing the STOP button for several seconds also ejects an inserted tape.
TRACKING up and down Allows the manual reduction of streaks which may appear on the
picture during regular or slow-motion playback. Reduces picture “jitter” during stop-action
(paused) playback.
TV Puts the remote control in TV mode. This button will automatically turn on most RCA,
GE, and Proscan TVs.
TV/VCR Toggles the VCR between TV and VCR signals.
VCR Puts the remote control in VCR mode.
VOL (up and down) buttons Decrease or increase the TV volume.
Using the INPUT Button
Use the INPUT button to toggle through the available Video Line Input sources (toggles
between line input(s) and regular broadcasting) and to view the connected component’s image
(like a camcorder’s playback picture) through the VCR.
1. Press the remote control’s VCR button to place the remote control in VCR mode. Make
sure that the VCR is turned ON.
2. Press the remote control’s INPUT button to tune to its Video Line Input source which
allows you to see the component’s image.
3. Press the INPUT button again to tune back to the broadcast image you were previously
watching through the VCR.