Great Dane GSRKA1934S - Manual (Page 27)

SERVICE TRANSMISSION
SERVICE TRANSMISSION- 25
A
B
Remove two cap screws (A).
Remove rear shield (B).
CAUTION: Avoid injury! Tensioning spring is
under high tension. Wear gloves and safety
glasses, and use a spring puller to install and
remove spring.
4 ⅝” - 5”
C
D
E
F
G
Picture Note: Traction drive belt idler pulley bottom view.
Insert 3/8 in. breaker bar into hole (C) and rotate idler
pulley (D) forward to ease tension on traction drive belt.
Remove traction drive belt (E).
Installing Traction Drive Belt:
NOTE: Install the traction drive belt (E) in front of an-
chor cap screw (F).
3.
4.
5.
6.
4 ⅝” - 5”
C
D
E
F
G
Install traction drive belt (E) on drive sheaves (G) as
shown. Ensure that traction drive belt is positioned in
front of anchor cap screw (F).
Insert 3/8 in. breaker bar into hole (C) and rotate idler
pulley (D) forward for additional clearance to install
traction drive belt.
Install rear shield.
Install mower deck drive belt.
Checking and Adjusting Motion Control Linkages
CAUTION: Avoid injury! Engine exhaust fumes
contain carbon monoxide and can cause seri-
ous illness or death.
Move the machine to an outside area before
running the engine.
Do not run an engine in an enclosed area
without adequate ventilation.
Connect a pipe extension to the engine ex-
haust pipe to direct the exhaust fumes out
of the area.
Allow fresh outside air into the work area to
clear the exhaust fumes out.
•
•
•
•
NOTE: Check and adjust motion control linkages with
the machine parked on a hard, level surface.
Checking Motion Control Linkages:
1. Park machine safely. (See Parking Safely in the
SAFETY section.)
1.
2.
3.
4.
1.