Great Dane GSRKA1934S - Manual (Page 37)

SERVICE MISCELLANEOUS
SERVICE MISCELLANEOUS - 35
Important: Avoid damage! Dirt and water in fuel can
cause engine damage:
Clean dirt and debris from the fuel tank
opening.
Use clean, fresh, stabilized fuel.
Fill the fuel tank at the end of each day’s
operation to keep condensation out of the fuel
tank.
Use a non-metallic funnel with a plastic mesh strainer
when filling the fuel tank or container.
•
•
•
Fill fuel tank at the end of each day’s operation to prevent
condensation and freezing during cold weather.
Park machine safely. (See Parking Safely in the
SAFETY section.)
Allow engine to cool.
Remove any trash from area around fuel tank cap.
Remove fuel tank cap slowly to allow any pressure built
up in tank to escape.
Fill fuel tank only to bottom of filler neck.
Install fuel tank cap.
Removing and Installing Rear Drive Wheels
Removing:
Park machine safely. (Refer to Parking Safely in the
SAFETY section.)
�
Lift machine with a safe lifting device centered under
tire support frame (A) on the side where tire is being
removed.
1.
2.
3.
4.
5.
6.
1.
2.
B
C
Remove wheel nuts (B).
Remove wheel.
Installing:
Install wheel with valve stem (C) facing out.
Install and tighten wheel nuts alternately until recom-
mended torque value is reached.
Tighten nuts to 102 N•m (75 lb-ft).
Lower machine.
Removing and Installing Front Caster Wheels
Removing:
Park machine safely. (Refer to Parking Safely in the
SAFETY section.)
Lift front of machine with a safe lifting device.
Remove nut (A) and wheel cap screw (B).
Remove wheel and spacers from yoke assembly (C).
Installing:
Install replacement wheel and original spacers.
Install wheel cap screw (B) and nut (A).
Tighten nut until wheel develops slight rolling
resistance.
Lower machine.
Tightening Rear Drive Wheel Hardware
Tighten rear wheel nuts to 102 N•m (75 lb-ft).
3.
4.
1.
2.
•
3.
1.
2.
3.
4.
1.
2.
3.
4.
1.