Gateway E-9520T - Manual (Page 17)

www.gateway.com
11
Some surge protectors and uninterruptible power supplies include simple line-conditioning
capabilities.
Uninterruptible power supplies
Use an uninterruptible power supply (UPS) to protect your server from data loss during a total
power failure. A UPS uses a battery to keep your server running temporarily during a power failure
and lets you save your work and shut down your server. You cannot run your server for an
extended period of time while using only the UPS. To buy a UPS, visit
www.gateway.com .
Removing and installing the bezel
To remove and install the bezel:
1 Follow the instructions in “Preventing static electricity discharge” on page 24 . Make sure
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
2 If the server is mounted in a cabinet, remove the server from the cabinet. For instructions,
see the instructions that accompanied the rail kit.
3 If the bezel door is installed, unlock (if necessary) and open it.
4 Open the server case by following the instructions in “Opening the server case” on page 25 .
5 Close the bezel door, then pull out on the three retaining tabs on the left side of the bezel
to disengage the tabs from the chassis.
Retaining tab
Retaining tab
Retaining tab