Gateway E-9520T - Manual (Page 55)

www.gateway.com
49
Replacing the system board
To replace the system board:
1 Follow the instructions in “Preventing static electricity discharge” on page 24 . Make sure
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
2 Follow the instructions in “Opening the server case” on page 25 .
3 Set the server on its side to make it easier to work on.
4 Remove the PCI expansion cards by following the instructions in “Installing and removing
PCI expansion cards” on page 37 .
5 Remove the memory modules by following the instructions in “Installing memory” on
page 33 .
6 Remove the heat sinks and processors by following the instructions in “Replacing or adding
a processor” on page 40 .
7 Disconnect all cables from the system board, noting their locations and orientation. (You
will reconnect the cables after you install the new board.)
8 Loosen the two thumbscrews (2) that secure the system board to the server.
9 Slide the system board toward the front of the server until it is free of the six retaining
standoffs (1), then lift the board from the chassis.
10 Place the old system board in a static-free bag for storage.
2
1
1 1
1 1