Gateway E-9520T - Manual (Page 37)

www.gateway.com
31
4 Make sure that the tray’s release lever is open, then slide the new drive fully into the empty
hot-swap drive bay and push the lever back into place.
Filling empty drive bays
Empty drive bays in the server must be filled by drive trays with dummy hard drives installed.
With the bezel removed, install the appropriate carrier, then replace the bezel by snapping it into
place on the front of the server. Dummy hard drives are included with your server and are installed
in unused drive bays.
Installing the optional diskette drive
To install the optional diskette drive:
1 Follow the instructions in “Preventing static electricity discharge” on page 24 . Make sure
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
2 Follow the instructions in “Opening the server case” on page 25 .
3 Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4 Push the diskette drive bay cover (EMI shield) (1) in from the front of the server.
Caution
The diskette drive is not hot-swappable. Before installing or removing the drive, make
sure that power is turned off and the power cord(s) is unplugged.