GN Netcom 9000MWD - Manual (Page 20)

Install the Handset Battery
To install the handset battery;
1. Open the battery cover as shown,
2. Insert the battery pack. Match the polarity
marks from the battery to the case (+ to
+).
3. When properly installed, the battery will
slide into position. DO NOT FORCE THE
BATTERY. Be sure the contacts are cen-
tered and the battery tab is placed into the
tab slot. Note: if the battery does not
seem to fit, turn the battery on the oppo-
site side and re-insert.
4. Replace the battery cover by inserting the
open end of the cover into the handset and
pressing the back into place.
Removing the Handset Battery and
Battery Cover
1. Insert a small screwdriver into bottom
slot. Lift the cover by lifting the screw-
driver. Do not lift the cover more that
1/2”.
2. Grip the handset tightly on the sides.
3. Depress the cover where the top portion
of the battery cover (middle of the hand-
set base) meets the handset. This will re-
lease the battery cover lock.
4. Slide the cover downward and remove.
DO NOT LIFT MORE THAN 1.2” UPWARD
Battery Placement Tab Must Be
Placed Into Housing Slot
20
3. Press Down
Center
2. Grip Here
4. Slide Downward
1. Insert small screw-
driver and lift upward
to release cover
Battery Cover
Removal