GE JGB910 - Manual (Page 19)

Power Outage
If a flashing time is in the display, you have
experienced a power failure. Reset the clock.
To reset the clock, touch the CLOCK pad.
Enter the correct time of day by touching
the appropriate number pads. Touch the
START pad.
19
Customer Service
Installation Instructions
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Using the clock and timer.
Not all features are on all models.
To Set the Clock
The clock must be set to the correct time of
day for the automatic oven timing functions
to work properly. The time of day cannot be
changed during a timed baking or self-
cleaning cycle.
Touch the CLOCK pad.
Touch the number pads.
Touch the number pads the same way you
read them. For example, to set 12:34, touch
the number pads 1, 2, 3 and 4 in that order.
If number pads are not touched within one
minute after you touch the CLOCK pad, the
display reverts to the original setting. If this
happens, touch the CLOCK pad and reenter
the time of day.
Touch the START pad until the time of
day shows in the display. This enters
the time and starts the clock.
To check the time of day when the display is
showing other information, simply touch the CLOCK
pad. The time of day shows until another pad is
touched.
Make sure the clock is set to the
correct time of day.
To Set the Timer
The timer does not control oven operations. The
maximum setting on the timer is 9 hours and 59
minutes.
Touch the KITCHEN TIMER ON/OFF
pad.
Touch the number pads until the
amount of time you want shows in the
display. The maximum number of
minutes that can be entered is 60. To
set additional time, you will need to set
it by hours and minutes. For example,
to enter 1 hour and 30 minutes, touch
1, 3 and 0 in that order.
If you make a mistake, press the KITCHEN TIMER
ON/OFF pad and begin again.
Touch the START pad. After pressing
the START pad, SET disappears; this
tells you the time is counting down,
although the display does not change
until one minute has passed.
When the timer reaches :00, the
control will beep 3 times followed by
one beep every 6 seconds until the
KITCHEN TIMER ON/OFF pad is touched.
The 6 second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a Timed
Cycle.
The timer is a minute timer only.
The CLEAR/OFF pad does not affect
the timer.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the KITCHEN TIMER ON/OFF pad, then touch
the number pads until the time you want
appears in the display. If the remaining time is not in the display
(clock, delay start or cooking time are in the
display), recall the remaining time by
touching the KITCHEN TIMER ON/OFF pad
and then touching the number pads to
enter the new time you want.
To Cancel the Timer
Touch the KITCHEN TIMER ON/OFF
pad twice.