GE 60-883-95R - Manual (Page 26)

Adding/Replacing Sensors 21
Door/Window Sensor 1. Remove the cover from the Door/Window Sensor.
2. Repeatedly press the Menu button on the back of the panel until the panel announces “Add
sensor. Press Status to select.”
3. Press the Status button on the front of the panel.
4. Press the Program button on the top of the Door/Window Sensor.
5. Repeatedly press the Power/Home/Away button until you hear the sensor type you want.
Door/Window Sensor type possibilities:
Activity Sensor type supervised
Activity Sensor type not supervised
6. Press the Status button to accept the sensor.
The system will announce the sensor name, type and number.
Freeze Sensor 1. Remove the cover from the Freeze Sensor.
2. Repeatedly press the Menu button on the back of the panel until the panel announces “Add
sensor. Press Status to select.”
3. Press the Status button on the front of the panel.
4. Press the Program button on the top of the Freeze Sensor.
5. Repeatedly press the Power/Home/Away button until you hear the panel announce “Press
status to accept Freeze Sensor type supervised”
6. Press the Status button to accept the sensor.
The system will announce the sensor name, type and number.
Water Sensor 1. Remove the cover from the Water Sensor.
2. Repeatedly press the Menu button on the back of the panel until the panel announces “Add
sensor. Press Status to select.”
3. Press the Status button on the front of the panel.
4. Press the Program button on the top of the Water Sensor.
5. Repeatedly press the Power/Home/Away button until you hear the panel announce “Press
status to accept Water Sensor type supervised”
6. Press the Status button to accept the sensor.
The system will announce the sensor name, type and number.
Smoke Alarm 1. Repeatedly press the Menu button on the back of the panel until the panel announces “Add
sensor. Press Status to select.”
2. Press the Status button on the front of the panel.
3. Remove the base of the Smoke Alarm.
4. Press the Status button to accept the sensor.
The system will announce the sensor name, type and number.
Carbon Monoxide Alarm See the instructions for adding or replacing a sensor using the programming buttons to add a
Carbon Monoxide Alarm.
Motion Sensor 1. Repeatedly press the Menu button on the back of the panel until the panel announces “Add
sensor. Press Status to select.”
2. Press the Status button on the front of the panel.
3. Remove the Motion Sensor from its mounting plate.
4. Repeatedly press the Power/Home/Away button until you hear the sensor type you want.
Motion Sensor type possibilities:
Activity Sensor type supervised
Activity Sensor type not supervised
5. Press the Status button to accept the sensor.
The system will announce the sensor name, type and number.
Repeater 1. Remove the Repeater cover.
2. Repeatedly press the Menu button on the back of the panel until the panel announces “Add
sensor. Press Status to select.”
3. Press the Status button on the front of the panel.
4. Press the tamper switch spring on the circuit board of the Repeater.
5. Press the Status button to accept the sensor.
The system will announce the sensor name, type and number.
Table 7: Programming Sensors
Sensor Type To Program