Turning on and projecting, No image is projected, Adjusting position and focus – Epson EMP-X3 User Manual
Page 5: Turning the projector off
English
Enlarge
Reduce
Normal
Wide Top
Wide Base
Extend
Retract
Rear Adjustable
Foot
* If you turn the power on straight after turning it off, the time before projection starts becomes longer than usual.
* For video equipment,
press "play" to start
playback.
Control Panel
Remote Control
Power Indicator
Lit
Flashing
Orange
Standby
Press
to start
projecting.
Green
Green
Warming up
Wait for a short
time (about 30
seconds).
Projecting
In this mode, you can unplug
the power cable.
Reading the Indicators
In this mode pressing
has
no effect.
(Accessory
Power Cable)
Examples
NEC
Panasonic
SOTEC
HP
TOSHIBA
IBM
SONY
DELL
FUJITSU
Macintosh Set mirror setting
or display
detection.
Depending on
your OS, you can
select them by
pressing
.
Turning on and Projecting
• When using the "Direct
Power On" feature, the
power turns on when the
power cable is connected.
• When using above an
altitude of about 1500 m,
make sure you set the “High
Altitude Mode” to “On”.
No image is projected
For notebooks and computers with liquid
crystal displays
Change the computer’s
output source. Hold
down the
key and
press the appropriate
key
(the one usually
labelled
/
). After
changing the setting,
wait a few seconds for
projection to start.
Computer’s "User’s
Guide"
* If the image is not
projected, press
.
For video equipment
Start playback then
press
.
Adjusting Position and Focus
(Setting up for the first time or after moving)
Raising the Projection Position (Adjusting the front foot)
When moving the projector, make sure
the front foot is retracted.
You can adjust the front foot to raise the
projection angle up to a maximum of 10
°.
Correcting Keystone Distortion
You can adjust the vertical tilt to a maximum of
about 30
°*.
* The greater the angle of tilt, the harder the
image is to focus. Setup the projector at a lower
angle of tilt.
• When the "Auto Keystone" function
is turned
"Off" in the configuration
menu, automatic keystone
correction is not performed.
(EMP-82/62 only)
• You can also make keystone
corrections from the configuration
menu.
• Hold down and press
for
more than one second to reset the
correction value to the default
setting.
• Adjust the horizontal tilt by turning
the left rear foot.
Adjusting Focus
After keystone correction and
sharpness adjustments, the image
may be unfocused.
Adjusting Projection Size
Turning the Projector off
Turn off all connected equipment.
Press
twice on the remote
control or control panel.
After the confirmation buzzer beeps
twice, unplug the power cable.
Electricity is consumed if only the projector's
power is turned off.
Attach the lens cover.
Foot Adjust
Lever