Epson EMP-X3 - Manual (Page 61)

56 Installation
Setting Up the Projector
The projector supports the following four different projection methods,
allowing you to choose the best method for displaying your images.
• For ceiling mount installation (suspending from the
ceiling), a special installation procedure is required.
Failure to install correctly may result in injury or
damage if the projector falls.
• Do not set this projector up on its side to carry out
projection,otherwise malfunctions may occur.
• If you use adhesives on the ceiling mount to prevent
the screws from loosening, or you use lubricants, oils
and so on, the casing may crack and the projector may
fall causing serious injury and serious damage to the
projector. When installing or adjusting the ceiling
mount, do not use adhesives to prevent the screws from
loosening and do not use oils or lubricants and so on.
• Front projection (Front projection)
• Rear projection using a translucent screen (Rear projection)
• The optional ceiling mount is required when installing
the projector on a ceiling. s p.67
• When using ceiling projection or projection using a
translucent screen, set the "Projection" command in
the "Extended" menu to match the installation method.
s
p.37
• Front/ceiling projection (Front/Ceiling projection)
• Rear/ceiling projection using a translucent screen
(Rear/Ceiling projection)