GE TRIPLEX 0150-0193C - Manual (Page 42)

0150-0193C 42 Calibur DVMR
e
Triplex
Notify Vidloss:
Notify Alarm:
Notify Record:
Notify Archive:
Notify Menu Access:
Notify Power Up:
Notify Connection:
Primary Host:
Backup Host:
Port:
Notification Interval (minutes):
DISABLE
DISABLE
DISABLE
0. 0. 0. 0
27
Immediate
DISABLE
DISABLE
DISABLE
0. 0. 0. 0
10
DISABLE
TCP/IP Dialout Notification Setup
[CANCEL] [OK]
One or more of these
fields must be set to
ENABLE to receive an
email notification of
the selected event.
The IP Addresses
of the PC on which
the WaveReader
Software resides
The Notification Interval can be set from 1 minute to 60 minutes, or immediately upon the event.
q Main Menu → Alarms → Archive Alarms
Selecting Enable from this menu will cause the unit to activate
Relay 2 if a malfunction occurs while archiving.
3.12 Macro
A macro is a recorded sequence of keystrokes. The number of macros depends on the number of
camera inputs (4, 10 or 16). Each macro can have up to 32 keystrokes.
Use this menu to:
•
Enter Macro Record mode.
•
Program a scheduled start time for a macro.
•
Edit the RS232 command string for each submacro.
q Main Menu → Macro → Macro Record
Note: Do not attempt macro programming while the front panel is locked.
To begin recording a macro:
1. Select the macro number you wish to record, then press the
Enter button. The unit will automatically exit the menu
system and go to a starting point. Macro Record mode
is indicated as F and the Macro Number on-screen.
2. From this point, begin recording the desired keystroke sequence. Record up to 32 keystrokes. If
32 keystrokes are exceeded, the unit will end the macro recording automatically.
Archive Alarm
ENABLE
Relay 2
Macro Record
01
Select Macro
Timed Macro Start
Edit Submacro
Macro Record