GE B640 - Manual (Page 44)

33
2
5
After selecting or entering a value, press
[START/COPY].
6
Repeat steps 4 and 5 as needed.
7
When the operation is complete, press [STOP].
Registration ends and the FAXPHONE returns to
standby mode.
DATA ENTRY OK
Registering your name and number
After 60 seconds of no operation panel input, the FAXPHONE returns
to standby mode and any unregistered changes are lost.
Entering a number _______________________________
Whenever you are prompted to enter a fax number or a telephone number, follow these
procedures.
Use the numeric buttons to enter the number.
TEL=
❚ You can enter up to 20 digits for your fax number or 50 digits for a speed dialing
number.
❚ Be sure to enter 1 and the area code, if necessary, to dial a different area code.
❚ Do not enter dashes, slashes, commas, or other punctuation.
Use the One-touch Speed Dialing buttons as follows:
❚ To enter a space between numbers, press [SPACE].
❚ If you make a mistake, press [CLEAR] and enter the number
again.
❚ To erase a previously registered number, press [CLEAR]. You
can also enter a new number over the old one.
If you need to enter a pause for any reason,
❚ Press [REDIAL/PAUSE] at the desired point in the sequence when entering a series
of digits.
❚ A pause within a number is 2 seconds long. The length of this pause can be
adjusted. See MID PAUSE SET in TX SETTINGS, p. 76. A pause at the end of a
number is fixed at 10 seconds.
Ch2.2 6/25/97, 2:41 PM 33