Getting to know your corvette – GM 2006 Corvette User Manual

Page 16

Advertising
background image

Heated Seats

(if equipped)

There is one

heated seat

control button

for each seat

located on the

center console.

Off: Press the

bottom of the

button ( )

to turn the

system off.

High: Press the top of the button once

to turn the system on high.

Low: Press the top of the button twice

to turn the system on low.

See Section 1 of your Owner Manual.

Getting to Know Your Corvette

16

Seat Controls

Six-Way Power Seats

The power seat controls are located on

the outboard side of the seat cushion.

• Move the front of the control up or

down to adjust the front of the seat

cushion.

• Move the rear of the control up or

down to adjust the rear of the seat

cushion.

• Slide the control forward or rearward

to move the entire seat forward or

rearward.

Power Lumbar and Side Bolsters

(if equipped)

• Press the vertical lumbar switch for-

ward to increase support and rear-

ward to decrease support.

• Pull the horizontal side bolsters

switch up to move the wings of the

seatback in closer and push the

switch down to move the wings out.

Window Indexing

To provide a tight seal around each

door, the window will automatically lower

slightly when the door is opened and

then automatically rise fully when the

door is closed.
If battery power is disconnected, the

indexing feature must be initialized

after restoring power by performing the

following procedure:
1. Close the door.
2. Raise the window by pulling up the

switch.

3. Hold up the switch for three seconds

after the window is closed and then

release it.

4. Hold up the switch again for three

seconds and then release it.

See Section 2 of your Owner Manual.

• To signal a turn, move the lever all of

the way up or down. The arrow on

the instrument panel cluster will flash.

The turn signal will stop flashing

when the turn is completed.

See Section 3 of your Owner Manual.

Advertising