Gateway Computer Drive - Manual (Page 6)

2
Chapter 1: Preparing to Install Your Drive
www.gateway.com
To install a drive, follow these steps:
1
Remove drive software (if replacing a Zip or tape drive).
2
Remove the existing drive (if replacing a drive).
3
Install the new drive.
4
Install drive software (if installing a Zip or tape drive).
Preparing your work area
To prepare your work area:
1
Find a place that:
■ Is clean. (Avoid dusty areas.)
■ Is a low-static environment. (Avoid carpeted areas.)
■ Has a stable platform on which to set your computer.
■ Is near a telephone in case you need help from Gateway Technical
Support. The telephone must be directly connected to a telephone jack
and cannot be connected to your computer.
2
Obtain these additional items:
■ A Phillips screwdriver.
■ A grounding wrist strap (available at most electronic stores).
■ A small container to hold hardware parts, such as screws, while you
are working.
■ The documentation that came with your computer.
Important If you do not have printed documentation, go to the
Gateway Web site (
support.gateway.com ) and print the
appropriate document before starting the installation
procedure.