Gaggenau CK 481-6 - Manual (Page 18)

Timer operation Note: only ever operate the appliance under
supervision.
It is possible to program an automatic switch-off
time for one or several of the cooking zones. Any
value between 1 and 90 minutes can be entered on
the timer.
It is also possible to use the timer independently.
The timer can also be used when the cooktop is
switched off.
Programming a switch-off time
• Set the cooking zone which you want to time to the
required cooking level.
• Touch the timer symbol. The timer display flashes
00. Select the required time using the
UP-/DOWN-symbols.
• The value is confirmed a few seconds later by an
audible signal and the timer starts. Alternatively
you can confirm the values by again touching the
timer symbol in the control panel.
• Touch the cooking zone in the display panel which
you would like to timer operate. The display
flashes the selected cooking level. Touch the
timer symbol.
• A spot appears next to the cooking level on the
cooking zone display. The timer is now set for this
cooking zone.
• After the elapse of the programmed time an
audible signal is sounded. The selected cooking
zone is switched off. Both the selected cooking
value and the timer flash. By touching any symbol
on the display the audible signal is switched off
and the cooking zone display shows zero.
17
Programming a switch-off time