Stovax Logic Hotbox & Convector Fire - Manual (Page 5)

6. CLEANING THE FIRE
USER INSTRUCTIONS
5
7. ARRANGEMENT OF FUEL BED
COMPONENTS
6.1 Remove the ceramic coals or pebblesand place on a dry,
clean surface. Remove the fuelbed and the burner cover
gasket.
6.2 Clean the burner and tray assembly using a vacuum cleaner
with soft brush attachment, ensure all debris is removed from
the burner ports.
6.3 Replace the ceramics by referring to section 7.
NOTE: CERAMIC PARTS ARE FRAGILE. THE SIDE AND
REAR PANELS ARE REVERSIBLE. ONE SIDE IS PLAIN, THE
OTHER SIDE IS REEDED. ASK THE CUSTOMER WHICH
SIDE IS PREFERRED AT THIS STAGE.
ONLY USE THE CORRECT TYPE AND QUANTITY OF
CERAMIC COMPONENTS. POINTS 7.1 TO 7.5 ARE
COMMON TO ALL FUEL TYPES AND LAYOUTS.
7.1 Position the burner cover gasket on the burner skin ensuring
the holes align with the ports. Take care as the front
left-hand hole is offset compared to the others.
See diagram 3, arrow A.
7.2 Position the flame baffle centrally on the tray and ensure the
stepped lower edge engages against the rear edge of the
burner skin. See diagram 4.
7.3 Place the rear panel against the rear of the box and slide
the side panels on either side of the flame baffle. Ensure they
locate in the brackets at the top of the firebox. DO NOT
SLIDE THEM ALL THE WAY BACK. See diagram 5.
7.4 Locate the top panel on top of the rear and side panels.
Finally push the sides fully towards the rear panel. This will
retain the top panel. See diagram 6.
7.5 Place the front coal centrally in the channel at the front of
the tray. See diagram 7. The relationship between the front
coal and flame baffle is shown in diagram 7.
3
4
5
6
7