Gateway FX542X - Manual (Page 61)

www.gateway.com
55
7 If you are replacing a drive, note any jumper settings on
the old drive and set the jumpers on the new drive to
be the same. If you are installing a new drive, follow the
manufacturer’s instructions.
8 Slide the new drive into the drive bay, line up the
thumbscrew hole on the drive bay with the screw hole
on the drive, then slide the drive release latch toward the
front of the computer to lock the drive into place. You
do not need to replace the thumbscrew because it was
originally installed for shipping purposes.
9 Connect the drive cables using your notes from Step 3 .
If you are installing a new drive, follow the
manufacturer’s instructions.
10 Replace the front bezel by following the instructions in
“Replacing the front bezel” on page 50 .
11 Replace the side panel by following the instructions in
“Replacing the side panel” on page 50 .
Replacing the memory card
reader
To replace the memory card reader:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 47 .
2 Remove the front bezel by following the instructions in
“Removing the front bezel” on page 49 .
3 Disconnect the memory card reader cables, noting their
locations and orientation. (You will reconnect the cables
after you install the new memory card reader.)
8513162.book Page 55 Tuesday, May 20, 2008 4:09 PM