Genie IWP Super Series 48643 - Manual (Page 17)

Part No. 48643 Genie IWP Super Series 15
Operator’s Manual Second Edition • Fourth Printing
a b a b
Test Auxiliary Platform Lowering
20 Raise the platform slightly.
Result: The inner frame wheels should lift off the
ground.
21 Disconnect the power source from the machine.
22 Turn the key switch to ground control
(if equipped).
23 Push in the auxiliary platform lowering button at
the ground controls.
Result: The platform should lower.
24 Connect the power source to the machine.
25 Turn the key switch to platform control
(if equipped).
26 Raise the platform slightly.
27 Disconnect the power source from the machine.
28 At the platform controls, push in the control
activate button and rotate the up/down switch in
the down direction.
Result: The platform should lower.
29 Connect the power source to the machine.
Test Manual Lowering
30 Twist to release the red Emergency Stop button
at the platform controls. Confirm that the
interlock display lights and the power light are
on.
31 Push in the control activate button and rotate
the up/down switch to the
UP
position to raise
the platform approximately 6 inches / 15 cm.
32 Activate the manual
lowering valve located
at the bottom of the
hydraulic cylinder.
Result: The platform
should lower.
Test Platform Raise and Lower
33 Push in the control activate button and rotate
the up/down switch to the UP position.
ANSI & CSA CE
a control activate button
b up/down switch
Result: The platform should raise smoothly,
free of hesitation.
34 Push in the control activate button and rotate
the up/down switch to the
DOWN
position.
Result: The platform should lower.
Test the Direction-reversing Safety Switch
(models with Power Wheel Assist Option only)
35 Pull and hold the function enable lever on either
side.
36 Press the thumb rocker switch and drive the
machine in the reverse direction.
37 Press the direction-reversing safety switch on
the end of the steer handle.
Result: The machine should travel in the
forward direction.
FUNCTION TESTS