Gateway kas303 - Manual (Page 51)

45
Using the universal remote control
www.gateway.com
To program a macro:
1
Press and hold down both the ENTER button on the remote control and
the macro button you want to program (M1, M2, or M3). The LED flickers
once.
2
First press the DEVICE button for the device that you want to control with
this macro, then press the operation buttons you want to program in the
order that you want them to execute.
3
Press the ENTER button on the remote control. If the macro was
programmed successfully, the LED flickers twice.
Remove a macro by following the above procedure except skip Step 2.
Change a macro by programming a new macro into the macro button. The new
macro automatically overwrites the old macro.
Using a macro function
To use a macro:
■ Aim the remote control at the remote control sensor of the component
that you want to operate, then press the macro button for the macro you
want to run.
The macro function of this remote control may not work with all components.
For example, the codes programmed into a MACRO button transmit at
0.5 second intervals. If the component cannot complete an operation within
0.5 seconds, it may miss the next code. In this example, you would not be able
to use that particular macro with the component.