Gateway kas303 - Manual (Page 76)

70
Chapter 5: Maintaining and Troubleshooting Your Receiver
support..gateway.com
Cleaning and maintenance
■ Your receiver is cooled by air circulated through the vents on the bottom
of the case. Keep these vents free of dust. With the receiver turned off and
unplugged, brush the dust away from the vents with a damp cloth. Be
careful not to drip any water into the vents. Do not attempt to clean dust
from the inside of your receiver.
■ Do not use abrasive or solvent cleaners because they can damage the finish.
■ Do not allow any excessive water or moisture to come into contact with
the surface of the receiver. If water or moisture gets inside your receiver,
operating problems and electrical and shock hazards may result.
■ Do not scratch or hit the case with your fingers or any hard objects.
Troubleshooting
As a general troubleshooting step turn you receiver off, then turn it on again.
This section provides some solutions to common problems you may experience
with your receiver.
If the problem continues, initialize your receiver by following the procedure
in “Initializing the receiver” on page 72.
No power
■ Connect the power cord securely.
■ Check the outlet using a lamp or another appliance.
Power shuts off abruptly during operation.
■ Switch off the power and check the speaker connections.
■ Adjust the speaker settings correctly.
■ Lower the volume.
No sound
■ Check the speaker connections.
■ Adjust the master volume.
■ Press the MUTE button to cancel the muting effect.