Gary Fisher Cronos - Manual (Page 11)

11 | GARY FISHER SERVICE INFORMATION
Finishing the installation
1. Attach the foot of the rear fender.
If the fender has a clip instead of a hole, remove the clip fastener with a drill. If necessary, use the
drill to enlarge the empty hole.
2. Place a screw through the hole in the foot of the fender and thread it into the frame
(Figure 16). Tighten to 40-60 Lb•in (4.5-6.8 Nm).
3. Put the wheels back onto the bike.
4. Attach the fender struts to the fenders and eyelets (Figure 17).
5. Adjust the struts for clearance and centering around the tire.
6. Tighten all the hardware: the bridge clip mounting screws, the strut attachments at
the eyelets, and the strut adjusters at the fenders.
figure 16. screw holding foot of fender to frame
figure 17. fender strut attached to eyelet