Gary Fisher Cronos - Manual (Page 20)

20 | GARY FISHER SERVICE INFORMATION
campagnolo ultratorque
The Cronus uses a special bearing system that has no parts that thread into the frame.
Instead, the bearings are a slip-fit into the frame. However, the Campagnolo UltraTorque
system requires you to attach bearing supports (seal seats) to the bottom bracket shell
of the Cronus (Figure 38). This section explains how to do that.
The seal seats might fit into the frame tightly. In this case, you might need to tap the
cups with a soft-faced mallet. However, do not use a hammer or bearing press to install
the bearings into the frame. If the bearing fit is too tight, make sure the seal seats are
clean and free of debris.
Tools and materials required
To complete the installation, you will also need the Campagnolo instructions, available at:
http://www.campagnolo.com/pdf/7225306_Ultra_torque_05_07.pdf.
Also read the warning: http://www.campagnolo.com/pdf/7225365_warning_Ultra_
Torque_0607.pdf
+ Crankset and bottom bracket (bearings come pressed onto the axle halves)
+ Plastic crank arm installation tool
+ LocTite® 638 retaining compound, TCG 408082
+ LocTite® primer 7649, TCG 408083
+ 5 mm Allen Wrench
+ Rock “N” Roll Super Coat grease
+ Bottom bracket parts
figure 38. campagnolo bearing set
Bearing Bearing
Wave washer
Washer Washer seal seat
Part description Campagnolo
Kit 407383
Drive side parts
Bearing Campy part
Seal seat 281825
Washer 281826
Non-drive side
parts
Bearing Campy part
Seal seat 281825
Wave
washer 281827
Washer 281826