Gary Fisher Cronos - Manual (Page 8)

8 | GARY FISHER SERVICE INFORMATION
To install the bearings
1. Apply a light coat of grease to the inner race of the lower bearing.
2. Install the bearing on the steerer (Figure 6).
+ The bearing is symmetrical, so either side is “right-side up.”
3. Apply a liberal coat of grease to the bearing seats of the head tube, both top
and bottom (Figure 7).
4. Slide the steerer (with the bearing installed) through the head tube (Figure 8).
5. Slide the upper bearing down the steerer and into the frame.
6. Slide the centering washer onto the steerer (Figure 9).
figure 6. Lower bearing on fork crown
figure 8. inserting the fork through the head tube
figure 7. Greasing upper bearing saddle
figure 9. slide the centering washer onto the steerer