Genie GS-5390 - Manual (Page 25)

Part No. 82828 Genie GS-3384 & GS-3390 & GS-4390 & GS-5390 23
Operator's Manual Second Edition • Third Printing
To Position Platform
1 Push and hold the lift function
enable button.
2 Activate the up/down rocker
switch in the desired direction.
To Steer
1 Press and hold the function enable switch on the
controller.
2 Turn the steer wheels with the thumb rocker
switch located on the top of the control handle.
To Drive
1 Press and hold the function enable switch on the
controller.
2 Increase speed: Slowly move the control handle
off center.
Decrease speed: Slowly move the control
handle toward center.
Stop: Return the control handle to center or
release the function enable switch.
Use the color-coded direction arrows on the
platform controls and on the platform to identify the
direction the machine will travel.
Machine travel speed is restricted when the
platform is raised.
Drive Select Switch
Machine on incline symbol:
Low range operation for inclines
Indicator Light On Red
If the indicator light is on red, push
in and pull out the red Emergency
Stop button to reset the system.
If the light stays red, tag and remove the machine
from service.
OPERATING INSTRUCTIONS
Indicator Light Flashing Red
If the indicator light is flashing red,
the platform is overloaded and no
functions will operate. An alarm will
sound at the platform controls.
Remove weight from the platform.
Push in and pull out the red Emergency Stop button
to reset the system.
If the platform is still overloaded, the light will
continue to flash.
To Extend and Retract Platform
1 Lift the platform extension lock handle to the
horizontal position.
2 Push the platform extension lock handle to
extend the platform to the desired position.
Do not stand on the platform extension while trying
to extend it.
3 Lower the platform extension lock handle.
Auxiliary Lowering
At the Ground Controls
Push and hold the lift function enable
button and activate the down function.
In the event of a power failure, use the
backup auxiliary lowering function.
At the Platform Controls
Push and hold the lift function enable button and
activate the up/down rocker switch in the down
direction.