System assembly – GE GXRV10ABL01 User Manual
Page 17
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
17
Reverse Osmosis System Assembly and Storage Tank Installation
1.
Hold the Reverse Osmosis assembly up to the wall surface where you will install it. Mark locations
for the hanger washers and screws.
2.
Fasten the hanger washers to the wall surface. Wood screws are included for fastening to a wood
surface. Provide other screws as needed.
3.
Hang the Reverse Osmosis assembly on the hanger washers.
4.
Connect the tubing to the storage tank: Run the length of 3/8
″ tubing (marked “STORAGE TANK”)
from the tee fitting on the Reverse Osmosis module to the tank shutoff valve. Use Teflon Tape
TM
to
prevent leaks.
Fig. 6A.
Storage tank
Hanger
washer
(2)
Screw
(2)
10″
2
″ minimum clearance for
changing cartridges
Fig. 6B.
RO faucet
Reverse Osmosis
system
Cold
water
supply
Sink
p-trap
Storage tank
*For drain line options see Filtration Drain Connection Installations section.