MITSUBISHI ELECTRIC LT-52244 - Manual (Page 14)

14 2. TV Setup
Change the Menu Language
Choose to display on-screen menus in either English or
Spanish (Español).
Select a menu language in the Setup menu.
1. With the Setup menu displayed, press to high-
light the Language icon.
2. Press to highlight either English or Spanish.
3. Press MENU to return the highlight to the top row of
icons.
Memorize Channels (Channel Scan)
For ANT 1/MAIN and ANT 2/AUX
Start a channel scan (memorization) from the Setup
menu.
Note: If using a CableCARD, the TV will automatically
acquire the complete list of available channels
from the service provider. Perform channel
memorization for
ANT 1 CableCARD service only
if you need to reacquire the channel list.
To start channel memorization
1. With the
Setup menu displayed, press to high-
light the Scan icon.
2. Press to highlight an input selection based on
your connections:
Input Condition
Ant 1 Air
Ant 2 Air When connected to an indoor or
outdoor antenna
Ant 1 Cable
Ant 2 Cable When connected to direct cable (no
cable box)
Additional TV Setup Using the Setup Menu
See chapter 5, “TV Menu Settings,” to:
• Edit channel options
• Set the TV clock
• Set the TV Timer
• Select an Energy Mode to manage power use while
the TV is off.
Initial TV Setup, continued
3. Press to highlight the on-screen START button.
4. Press ENTER to start automatic channel memoriza-
tion.
To stop channel memorization before
completion, press CANCEL.
5. When memorization is complete you can:
• Press MENU once to return to the top row of icons.
• Press MENU again to return to the Main menu.
• Press EXIT to watch TV.
After channels have been memorized:
• To tune to memorized channels, press
CH /
while watching TV on the ANT 1 or ANT 2 inputs.
• Use the Setup > Edit menu for additional channel
options, such as adding or deleting channels from
memory, naming channels, and saving favorite
channels in custom memory banks.
Setting Up TV Inputs
When You First Connect a Device
This TV’s Easy Connect™ Auto Input Sensing feature
detects most connections automatically. When you
first connect a device, the TV will:
a. detect the connected device and automatically
switch to it
b. prompt you to identify the device type
c. prompt you to perform NetCommand set-up for
the device
d. repeat these steps for any additional newly
detected devices
The tables below state which connections trigger Auto
Input Sensing.
Auto Detection Active No Auto Detection
INPUT video jacks ANT 1 and ANT 2
COMPONENT video jacks
HDMI
*
DIGITAL AUDIO OUT
AVR AUDIO OUTPUT, right (red) analog audio jack only
USB (USB photo port on side)
* If the device is powered off when connected, detec-
tion occurs when the device is next powered on.
Note: For connection and setup of a personal com-
puter, see the information later in this chapter.