MITSUBISHI ELECTRIC LT-52244 - Manual (Page 42)

42 5. TV Menu Settings
Setup Menu Options
Language
English
Spanish Display on-screen menus in either English or Spanish.
Note: To listen to audio in other languages (when available), see the section
on the
AV menu, Audio submenu, and refer to either Listen To > SAP (analog
signal) or Language (digital signal).
Scan
Ant-1 Air
Ant-1 Cable
Ant-2 Air
Ant-2 Cable Scan memorizes broadcast channels to make them easier to find. To start
channel memorization:
1. Highlight one of the input selections based on your connection to
ANT 1
or ANT 2:
• Air when connected to an indoor or outdoor antenna.
• Cable when connected to direct cable (no cable box)
2. Press to highlight START.
3. Press ENTER to start channel memorization for the selected input.
Setup Menu
Setup menu, Scan option
Use the Setup menu to:
• Select English or Spanish for menus and on-screen
text.
• Scan the channels available from the antenna or
cable service connected to the ANT 1 or ANT 2 jacks.
• Edit channel options, including channel locking.
• Set the TV’s internal clock.
• Set the TV Timer to turn on the TV automatically at
a designated time.
• Set the energy mode for power consumption when
the TV is powered off.
Notes on Scan and channel memorization:
• Channel memorization may take up to 15 minutes
to complete.
• To stop channel memorization before completion,
press CANCEL.
• When watching TV, press CH to move through
memorized channels.
• If you restart memorization, previously memorized
channels for the selected input will be erased.
• If using TV Guide Daily, the channels displayed
and their order are independent of the TV’s
channel memorization. Refer to Appendix C for
more information.
• If using a CableCARD, the complete list of avail-
able channels is provided through the CableCARD.
There is no need to perform channel memorization
for
ANT 1 CableCARD service unless you wish to
clear channels from memory and reacquire the
channel list from the service provider.
• To add a digital channel that does not appear in the
Edit menu without repeating channel memorization:
1. Look up the physical channel number
for the new digital channel. The website
www.antennaweb.org can help you find the
physical channel number.
2. Tune to any channel on the ANT 1 or ANT 2
input your antenna is connected to.
3. Use the number keys and
—
CANCEL to enter the
physical channel number followed by “-1” and
ENTER. For example, for physical channel 36,
press
3 6 — CANCEL 1 ENTER.
The TV will search for a digital channel on the channel
36 frequency. When it finds the channel, it will:
a. Add the channel to memory.
b. Change the channel number to the virtual
channel number sent by the broadcaster.
c. Add any associated sub-channels to
memory.