Moxa Technologies 5600 - Manual (Page 35)

NPort 5600 Series User’s Manual Web Console Configuration
Auto report to IP
Setting Factory Default Necessity
E.g., 192.168.1.1
(IP addresses of the form x.x.x.0 and
x.x.x.255 are invalid.) None Optional
Reports generated by the Auto report function will be sent automatically to this IP address.
Auto report to TCP port
Setting Factory Default Necessity
E.g., 4001 None Optional
Auto report period
Setting Factory Default Necessity
Time interval (in seconds) 10 Optional
Serial Settings
Click on Serial Settings, located under Main Menu, to display serial port settings for ports 1 and
2.
NOTE: Since this figure was borrowed from the manual of NPort 5200, which has only 2 RS-232
ports, there are only 2 ports shown in this figure. Once you have completed the hardware
installation of NPort 5600, there should be either 16 or 8 ports shown in the figure, depending on
the model you installed. The steps for changing the settings of the other ports are the same as those
for Port 1 and Port 2.
To modify serial settings for a particular port, click on either Port 1 or Port 2 under Serial
Settings, located under Main Menu on the left side of the browser window
5-9