Multi-Tech Systems 40-01459-D0-001 - Manual (Page 35)

TCP/IP Direct Connect 29
Windows NT
The following step-by-step procedure will install the TCP/IP Direct Connect and
configure it for use without MPC+. Installation and configuration of TCP/IP Direct
Connect using MPC+ is discussed in the “MPC+ for Windows NT Installation
Guide”.
The PBSA driver must be installed before TCP/IP Direct Connect (see Page 10).
Step
1. From the Windows NT Control Panel invoke Network configuration (Figure
5-11).
Figure 5-11. Invoking Network Configuration
2. Click on the Adapters tab (Figure 5-12). Make sure the adapter is listed. If not,
you must install the adapter before installing TCP/IP Direct Connect (Refer to
Page 8).