Networks & services > network configuration, Networks & services – Multi-Tech Systems MULTIMODEM MTCBA-C-EN-NX User Manual
Page 35
Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F)
35
Networks & Services
Networks & Services > Network Configuration
Networks or Hosts can be added here. The options to Delete or Edit a network after it has been defined and added
are available by using the table at the bottom of the screen.
Network Configuration
Enter the Name, IP Address, and Mask for a new Network or Host.
Notes:
•
A Network/Host Name cannot be edited.
•
A Network/Host cannot be deleted if it is used in another configuration.
•
Network/Host changes are reflected in all the configurations in the Web Management software where
they are used.
•
A Network/Host added here will be displayed in the following sections: Static Routes, DNAT, and
Packet Filters.
Name:
Enter the name of the Network/Host. The same address-mask pair should not already
be present in the displayed list.
IP Address:
Enter the IP Address of the Network/Host. The same address-mask pair should not
already be present in the displayed list.
Subnet Mask:
Enter the Network Mask of the Network/Host. For Host addresses, the mask is entered
as 32.
Note:
See Appendix A -- Table of Commonly Supported Subnets.
Add Button:
Click
the
Add button. The defined network is added and will display at the bottom of the
screen.