Dhcp server > subnet settings, Dhcp server – Multi-Tech Systems MULTIMODEM MTCBA-C-EN-NX User Manual
Page 43
Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F)
43
DHCP Server
DHCP Server > Subnet Settings
General Configuration
DHCP (Dynamic Host Configuration Protocol) is a protocol that allows individual devices on an IP network to get
their own network configuration information (IP address, subnet mask, broadcast address, etc.) from a DHCP
server. The overall purpose of DHCP is to make it easier to administer a large network.
DHCP:
Enable/disable the DHCP server.
Subnet:
Enter the subnet address. For the subnet change, all the ranges have to be deleted;
otherwise, you would not be able to edit the subnet.
Mask:
Enter the subnet mask address.
Gateway:
Enter the gateway address.
DNS:
Enter the DNS address.
Lease Time:
Select the DHCP Lease Time from the selection box. Lease time is set in days, hours,
and minutes. A Lease Time of 00-00-00 is an Infinite Lease Time.
Submit
Click the Submit button to save these settings.
Note:
You must click Save and
Restart once you have completed and submitted all the screens on which you have
made changes.
Subnet Settings
From-To Range:
Enter the range of IP address for the subnet. For every range, the From and the To
addresses have to be entered in these fields.
Add:
Click the Add button. The address range is added and will display in the table at the
bottom of the screen. Once the range displays, you can delete if necessary.
Note:
See
Appendix A – A Table of Commonly Supported Subnets.