Multi-Tech Systems MVP110 - Manual (Page 15)

15
Configure Host MultiVOIP
The IP address is your unique LAN IP address, and the
Gateway address is the IP address of the device
connecting your MultiVOIP to the Internet.
Click OK when you are finished.
13. The Channel Setup dialog box displays. It is used to
define the voice/fax channel interface, voice coder, fax
parameters, billing options, security settings, and regional
phone parameters (tone pairs).
14. If you are connecting a station device such as an analog
telephone, a fax machine, or a Key Telephone System
(KTS) to the Voice/Fax connector on the back of the unit.
In the Max Dial Digits box, enter the maximum number of
digits allowed when dialing a phone number. The default
setting is 5. In the Inter Digit Time box, enter the
maximum amount of time in milliseconds that the unit will
wait before mapping the dialed digits to an entry in the
Phone Directory Database. If too much time elapses
between digits and the wrong numbers are mapped, you
hear a rapid busy signal. If this happens, hang up and dial