Multi-Tech Systems MT5634ZLX User Manual
Page 36
36
MultiMobile User Guide
MT5634ZLX/E
M3
Speaker off during dialing and on until carrier present
Nn
Select negotiate handshake
N0
When originating or answering, handshake only at the communication rate specified
by S37 register and “ATBn” and no fallback
N1 *
When originating or answering, start handshaking only at the communication
standard specified by S37 register and “ATBn”. During handshake, fallback to a
lower speed may occur.
On
Go on-line
O0
Return modem to a previously established state (return to data mode).
O1
Begin a retrain sequence, then return to on-line state.
O3
Issue a rate re-negotiation, then return to on-line state.
P
Enable pulse dialing (Disabled in CTR 21 approved models)
Qn
Result code display options
Q0 *
Result code enabled
Q1
Result code disabled
T
Enable tone dialing
Vn
Result code form
V0
Display result code in numeric form (see also the result code options table)
V1 *
Display result code in verbose (text) form
Wn
Select extended result code options
W0
CONNECT result code reports DTE speed. Disable protocol result codes. (See also
the “Result Code Options Table”)
W1
CONNECT result code reports DTE speed. Enable protocol result codes.
W2 *
CONNECT result code reports DCE speed. Enable protocol result codes.
Xn
Select result codes/call progress options.
X0
Display CONNECT or “1” for all speeds. Ignore dial tone and busy tone detection.
X1
Display connect message and the modem’s data rate, and an indication of the
modem’s error correction and data compression. Ignore dial tone and busy tone
detection.
X2
Display connect message and the modem’s data rate, and an indication of the
modem’s error correction and data compression. Check dial tone before proceeding
dialing, ignore busy tone detection.
X3
Display connect message and the modem’s data rate, and an indication of the
modem’s error correction and data compression. Ignore dial tone before proceeding
dialing, check busy tone after making dialing.
X4 *
Display connect message and the modem’s data rate, and an indication of the
modem’s error correction and data compression. Check dial tone and busy tone.
X5
Same as X4.
X6
Same as X4.
X7
Display CONNECT or “1” for all speeds. Check dial tone and busy tone.