Marantz Mrantz DLP Projector VP-11S2 - Manual (Page 12)

4
ENGLISH
!3
!4
q Focus ring ( ☞
P.11)
Adjust the picture focus.
w Zoom ring (
☞
P.11)
Adjust the size of the projected image.
e Lens Shift knob ( ☞
P.12)
Manually adjust the position of the image vertically.
r / I button (
☞
P.18)
Press to turn the projector ON or STANDBY mode.
t MENU button ( ☞
P.21)
Display the on-screen menu.
Front and Top View
PROJECTOR LAYOUT AND FUNCTIONAL OVERVIEW
y ENTER button
Press to enter the selected menu item.
u INPUT SELECT button (
☞
P.18)
Selects the input signal (COMPONENT 1,
COMPONENT 2, S-VIDEO, VIDEO, RGB, HDMI 1
and HDMI 2).
i PATTERN button ( ☞
P.11)
Projects a focus pattern on the screen.
o The 3 / 4 / 1 / 2 buttons
Control the MENU cursor.
Note: Pixel defects
DLP ® chip is one of the most advanced
technologies for consumer products. The
DLP
® chip made by high precision technology,
however some pixel defects may be found on
the projected image. We are trying our best to
control the quality in order to reduce the
number of defective pixels. It is almost
impossible to have zero pixel defects, even
using the most advanced technology. This is
not a problem only for Marantz, but all DLP
®
projector manufactures. Therefore we have to
note that the warranty does not cover the
DLP
® chip for pixel defects. We appreciate
your understandings.
Note: Lamp
SHP lamp is one of the most advanced
technologies for consumer products. The
lamp made by high precision technology,
however some lamps might be failing before it
reaches its life. And projector’s brightness is
getting darker along with accumulated lamp
usage hours. We are trying our best to control
the quality in order to reduce lamp failures. It
is almost impossible to have zero failure, even
using the most advanced technology. This is
not a problem only for Marantz, but all
projector manufactures. Therefore we have to
note that the warranty does not cover the SHP
lamp for lamp failures: explosion, and non-
lighting except initial use. And also we have to
note that the warranty does not cover the SHP
lamp for lamp failures: flickering, and getting
darker along with accumulated lamp usage
hours. We appreciate your understandings.
!0 ON indicator
Lights up blue when power is ON. When power is
shut OFF, the lamp flashes for about 1 minute
before going out.
!1 STANDBY indicator
Lights up green when the projector is on standby.
!2 WARNING/LAMP indicator
Flashes or lights up when something is wrong with
the lamp cover, lamp, fan, or temperature inside
the projector.
For more information on the error mode, see the
“Error Mode List” (
☞
P.35)
!3 Ventilation holes (intake)
!4 Ventilation holes (exhaust)
Notes:
• Do not place anything near the ventilation
holes to avoid overheat inside the unit.
• Do not place your hand or objects near the
ventilation holes; the air is coming out.
IR sensor
Projection
Lens