Multi-Tech Systems BA-Series - Manual (Page 30)

30
MultiModemBA User Guide
Flash On Hook !
Some switchboard systems react to a momentary On Hook. An exclamation mark inserted in the
command causes the modem to
“flash” on hook for a half of a second, as if you had held the switch
hook button on a telephone down for a half second.
For example, to flash On Hook after dialing the number 555-1234 in order to transfer to Extension
#5678, you might enter
ATDT5551234,,!5678. The commas cause a 4 second pause (just to be
safe).
"Calling Card" Detect Tones $
The modem has the capability to detect AT&T "calling card" tones for the purpose of utilizing the
user's calling card number to originate an on-line connection. An $ symbol placed in the dialing string
causes the modem to pause and wait for an AT&T "calling card" or a 1600 Hz tone (prevalent in the
United Kingdom). When the tone is detected, the rest of the dialing string is processed. If no tones
are detected within the time period set by S-Register S7 (default 45 seconds), the modem will abort
by indicating a
NO CARRIER message. Hitting any key also aborts the $ command.
The following is an example of this command:
ATDT
1028806127853500
$
123456789
(access/phone number) (credit card number)
Quiet Answer @
The @ command causes the modem to wait before processing the next symbol in the dialing string.
The wait is for one or more ringbacks followed by 5 seconds of silence. If the time specified by S-
Register S7 passes before the rings and silence, a
NO ANSWER (R) result code is processed. The
@ command is used for accessing a system that does not provide a dial tone.
For example, ATDT5551212@6313550 causes the modem to dial the first number (555-1212) and
wait for the time specified in S7 for at least one ringback and 5 seconds of silence. If a busy signal is
detected, the modem hangs up and generates a BUSY result code. If it does not detect 5 seconds of
silence, a NO ANSWER result code is generated after hanging up. If 5 seconds of silence is
detected, the second number (631-3550) is then dialed.
4.4.3 Phone Number Memory Commands
Storing Phone Numbers D...N
A telephone number and command line of up to sixty characters may be stored in the modem’s
number memory. As many as ten of these numbers may be stored. Each number will be given a
name, using the codes N0, N1, N2 up to N9.
A phone number is stored by entering ATD, then the number as it would be dialed, along with any P,
T, R, ; or comma characters, and then entering N followed by the number’s “name,” which would be
any number from 0 through 9, and then hitting RETURN.
For example, the tone-dialed number 1-612-631-3550 would be stored as number N3 by entering
ATDT16126313550N3 and RETURN. The number is not dialed with this store command. After
storing a number, check to see that it has been stored correctly by typing
ATL and hitting RETURN.
When phone numbers are stored, the entire command line is also stored so that you can effectively
create a macro for each number. For example, if you know a particular number needs to have
extended result codes, detect busy or dial tone, error correction, Xon/Xoff flow control, pacing, and
data compression enabled, the command line would be:
ATX4&E1&E5&E13&E15DT16126313550N3. This would store the entire command at location N3.