Service and maintenance (cont’d), Element cleaning/ replacement, Thermostat removal (cont’d) – Maytag HRX40DERS User Manual

Page 18

Advertising
background image

18

Service and Maintenance (cont’d)

5. Remove the block of insulation to expose the terminal

cover.

3. Attach a hose to the water heater drain valve and put the

other end in a floor drain or outdoors. Open the water
heater drain valve. Open a nearby hot water faucet which
will relieve pressure in the water heater and speed draining.

4. Remove the two screws securing the access panel, and

remove panel.

WARNING

The water passing out of the drain valve may be
extremely hot. To avoid being scalded, make sure all
connections are tight and that the water flow is
directed away from any person.

2. Turn off the water supply to the water heater at the water

shutoff valve or water meter.

WARNING

HAZARD OF ELECTRICAL SHOCK! Before removing
any access panels or servicing the water heater,
make sure the electrical supply to the water heater
is turned “OFF”. Failure to do this could result in
DEATH, SERIOUS BODILY INJURY, OR PROPERTY
DAMAGE.

NOTE: These instructions are written for element cleaning
and element replacement for the lower element. If it is nec-
essary to clean or replace the upper element, then repeat
these instructions.

To remove the element from your tank in order to clean or
replace it:

1. Before beginning turn “OFF” the electric power supply to

the water heater.

Element Cleaning/
Replacement

9. Put plastic terminal cover back in place.

10. Replace the insulation block and pad to cover the thermostat.

11. Replace access panel, then turn the electric power “ON”.

Thermostat Removal (cont’d)

Advertising
This manual is related to the following products: