Metrologic Instruments StratosS MS2220 - Manual (Page 30)

24
I NSTALLATION
C ABLE I NSTALLATION (I NTERFACE S PECIFIC )
OCIA
8. Connect AC power to the transformer. If the AC outlet is equipped with an on/off switch, turn the power on.
9. Turn on the host system.
10. Configure the StratosS to match the host system’s OCIA parameters.
Refer to the MetroSelect Configuration Guide ( MLPN 00-02407 x) under Section I: OCIA for enabling and setting
OCIA parameters.
Refer to the MS2 x20 Stratos Series Scanner/Diva Scale Configuration Addendum (
MLPN 00-02272 x) for scale,
dual cable and single cable configuration bar codes.
xx** Specifies international connection. See the Base Kit Components and Optional Accessories section of this guide for a
complete listing.
See power source caution statement on page 10 of this manual.
Figure 21. OCIA Cable Installation Schematic