Mercury INSTALLATION MANUAL D7.3L D-TRONIC - Manual (Page 42)

D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 42 of 90
3. Align rear engine mounts with inner transom plate mounts. Set engine onto front mounts
and inner transom plate mounts, while simultaneously aligning exhaust elbow with ex-
haust tube. (Do not relieve hoist tension.) nd
IMPORTANT: Engine attaching hardware must be installed in sequence shown.
4. Install both rear engine mounting bolts and hardware as shown. Torque to 35-40 lb-ft
(47-54 Nm).
22032
a
c
b
d
g
f
e
a -
Rear Engine Mount
b -
Inner Transom Plate Mount
c -
Bolt
d -
Washer
e -
Spacer
f -
Fiber Washer
g -
Double-Wound Lockwasher
5. Relieve hoist tension and disconnect sling from engine lifting eyes.
NOTE:
Installing Engine Lifting Eye Tool shown will help equalize load on hoist during align-
ment procedure.
6. Install lifting eye tool into metal bar with threaded hole near port end of engine oil cooler.
75956 76021
71961
b
a
a -
Lifting Eye Tool
b -
Threaded Hole