Mercury INSTALLATION MANUAL D7.3L D-TRONIC - Manual (Page 53)

D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 53 of 90
NEUTRAL SAFETY SWITCH CONNECTION
1. Connect neutral safety switch wires at instrument panel and remote control. Refer to ap-
propriate wiring diagram. Secure connections as shown and coat with Liquid Neoprene.
Slide rubber sleeve over connections.
YEL/RED
YEL/RED RED 36BC2
PUR 36BC3
PUR 36BC1
PUR 36BC
a b
a
c
c
d
a -
Instrument Harness Wires
b -
Two Wire Connector
c -
To Remote Control
d -
Rubber Sleeves
TRIM POSITION SENDER CONNECTION
1. Connect trim position sender leads from gimbal housing to leads from engine harness.
24841
BLK
BLK
a
b
YEL 107
BLK GND3
a -
From Engine Harness
b -
From Gimbal Housing
MERCATHODE CONTROLLER
1. Connect electrical leads to controller assembly.
2. Apply a thin coat of Liquid Neoprene to ALL electrical connections.
75955
a
22232 b c d e
a -
Controller Assembly Location
b -
ORANGE Wire - From Electrode on Transom Assembly
c -
RED/PURPLE Wire - Connect (Other End) to Positive (+) Battery Terminal
d -
BLACK Wire - From Engine Harness
e -
BROWN Wire - From Electrode on Transom Assembly