Marantz PMD670 - Manual (Page 20)

Skip
An EDL Mark changed to 'Skip' will be skipped
during EDL playback (playback with EDL PLAY
switch at ON). Playback will skip to the beginning
of the next EDL Mark.
A skipped EDL recording is not erased. The
recording is still on the CF card. The skipped EDL
recording will play if the EDL PLAY switch is at
OFF. You can change the type later.
EDL A-B looping
To playback an EDL A-B loop press the PLAY/
PAUSE button
to begin playback then press
and release the A-B REPEAT button.
If there is an error, for example there is an EDL
Mark of type Loop_A but no EDL Mark of type
Loop_B an error message is displayed.
Only one EDL A-B loop can programmed. When
a 'Loop_A' or 'Loop_B' exists on a CF card and
another is created the old mark automatically
changes to a 'Skip'.
Erase
When an EDL mark is erased the remaining EDL
marks are automatically renumbered from 1
through the number of EDL marks on the CF
card.
L
R
-dB over 0 2 6 12 20 40 00
-dB
TRACKTIME
TRACK
Example
display.
Press and release the MARK/ EDIT button to
tab through the EDL Mark types: Point, Skip,
Loop_A, Loop_B, and Erase. When the type you
want to change the EDL Mark to is flashing press
and release the ENTER button
.
Writing will be displayed briefly and the PMD670
will return to stop mode.
L
R
-dB over 0 2 6 12 20 40 00
-dB
TRACKTIME
MARK
- 20 -
Edit mode
Edit mode includes: Renumber (renumber
tracks), TrkERASE (erase a track),
TrkMkERASE (erase an EDL mark),
AllMkERASE (erase all EDL marks), and FOR-
MAT (format the CF card).
How to renumber tracks
If you have erased tracks from the CF card it is
easier to locate recordings if the tracks are
renumbered.
From stop press and hold the MARK/ EDIT
button for about 2 seconds to enter Edit mode.
Renumber flash-
ing in the display.
While Renumber is flashing (5 seconds) press
and release the ENTER button
. (Or press
and release the STOP button to cancel.)
EXECUTING will be displayed and the percent-
age executing will increase to 100%.
100% done will be displayed momentarily. Then
the PMD670 and the display will return to stop
mode.
How to erase tracks
From stop press and hold the MARK/ EDIT
button for about 2 seconds to enter Edit mode.
Renumber flashing
in the display.
While Renumber is flashing (5 seconds) press
and release the MARK/ EDIT button again.
TrkERASE flashing
in the display.
While TrkERASE is flashing (5 seconds) press
and release the ENTER button
.