Maytag MDE 9901 - Manual (Page 13)

13
START TUMBLE DRYING
Press the button.
The text at the lower edge of the
display indicates that the programme has star-
ted. The text field of the display shows the cur-
rent stage of the programme while it is in pro-
gress.
NOTE
If the child lock is on, the button must
be held down for 3 seconds in order for the
programme to start. See Chapter 3, Child safe-
ty, for details of how to switch the child lock on
and off.
Remaining drying time
The approximate remaining drying time is esti-
mated within four minutes of the start of the
drying programme. Only the time for the Ti-
med dry programme and Air fluff programme is
indicated for venting dryers.
The time is shown in hours and minutes (al-
ternating) at the bottom right of the display
together with the
symbol. Note that the
time also includes cooling.
DURING TUMBLE DRYING
Putting in more washing
Open the door and the drum will stop
automatically. To restart: Close the door and
press the
button.
Changing programme
Press the button for three seconds. The
programme will then be zero set and you can
choose a new programme.
DRYING PROGRAMME ENDED
The text on the bottom edge of the
display indicates that the programme has
ended.
If the Anti-crease option is activated, the
drum will rotate every minute for a certain pe-
riod after cooling. The text [“Anti-crease”] is
indicated in the display during this period. The
programme can be stopped at any time by ope-
ning the door.
When the programme ends:
• Clean the lint filter after each drying opera-
tion, see below. An error message will be dis-
played if the lint filter needs to be cleaned.
• Empty the condensation water container.
WARNING!
If the lint filter becomes completely clogged
the overheat protection device may trigger. The
device must then be reset to enable the machi-
ne to be started, see Chapter 12, Trouble shoo-
ting.
66
55