Maytag MDE 9901 - Manual (Page 27)

27
FAULT INDICATIONS
Error messages appear in the display text field if
faults occur while a programme is in progress.
To exit the error messages after correcting the
fault as described below, switch the machine off
or change the programme.
The error messages that can be displayed are:
Maximum programme time. When the mach-
ine has run for its maximum time (three hours)
it will stop. Ensure first that all fuses for the
machine are intact. To exit the error message,
switch the machine off or open the outer door.
If this does not help, phone for service.
Over flow. Indicating that the condensation wa-
ter container is overfilled. Empty the container
and restart. If the message is repeated it may be
because the lower water magazine is full, due to
the pump or hoses being clogged or malfunctio-
ning. If condensation water is pumped out di-
rect to the drain, check to ensure there are no
kinks or stoppage in the hose. If this does not
help, phone for service.
Sensor fault. Fault in the moisture sensor. This
error message can also appear if you should start
the dryer when it contains dry items or when it
is empty. To cancel the message, simply open
the dryer door. If this does not work, phone for
service.
Thermistor fault. Phone for service.
WRONG LANGUAGE ON THE DISPLAY
If the language on the display becomes altered
for any reason, it can be restored to the initial
language again.
The available languages are Eng (AUS),
Svenska, Dansk, Norsk, Suomi, Francais, Ne-
derlands, Italiano, Espanol, Russia, Deutsch,
Eng (US).
Proceed as follows to change the language:
Turn the main power switch, , of and
then turn it on again. Press the
Enter
button five
times, then press the
P1
button five times.
These ten times must be completed within fif-
teen seconds.
Within three seconds after pressing
P1
the
last time, step to the desired language using the