Miele DA 229-2 - Manual (Page 29)

Retaining plate A
^ Drill two 1
/
8
" (3 mm) holes, one at S +
3" (75 mm) and one at S + 15
3
/
4
"
(400 mm) on the center line (see "Ap-
pliance dimensions").
^ Lightly secure retaining plate A into
position using 5 x 40 mm screws
through the two holes and use the
notches to align with the center line.
^ Drill 6 more 1
/
8
" (3 mm) holes through
the now fitted retaining plate.
^ Screw four 5 x 40 mm screws into the
upper and lower set of holes to se-
cure retaing plate A.
Installation
29